+- Silgrad Tower from the Ashes (https://www.silgradmodding.net/forum)
+-- Forum: Discussions for Silgrad Tower TES IV (Oblivion) & TES III (Morrowind) (https://www.silgradmodding.net/forum/Forum-Discussions-for-Silgrad-Tower-TES-IV-Oblivion-TES-III-Morrowind)
+--- Forum: Tavern TES III (https://www.silgradmodding.net/forum/Forum-Tavern-TES-III)
+--- Thread: Old palace (/Thread-Old-palace)
Old palace - agram - 06-02-2007
One question: Will the old palace in Kragenmoor be avalible for claiming? That would be fun to work on.
RE: Old palace - bob196045 - 06-02-2007
Yes it will
I was going to open a discussion about it, I guess this could be it to stat it off
I was hoping their would be interest in it and what ideas for the interior were out their to decide on
Enjoy
Bob
- agram - 06-02-2007
Then let the discusion begin! :check:
I will see if i have some interior for the entry area (i collected a good deal over the years from PES), who knows...
The other areas could be made from redoran/velothi interiors. I dont know how big this palace is because i dont have the exterior, but this could also go several levels underground.
I dont know yet, but hey, we have this discusion to decide how and what to do. =)
I would be interested in working on interior when we decide.
Also not for this but i didnt want to create a new thread: if you need help with some books i could give it a try.
- bob196045 - 06-02-2007
we can start by looking at it
heres to shots front and rear
Basically its a bunch of the Holamayan Entries stacked on top of each other in various sizes with a balcony on the back side which overlooks the landscape, probably the queens master chambers
So I would assume the inside would be the in_v_roomhol_01 with wings on each side of the same in_v_roomhol_01, just smaller
If we did use this interior we would have to come up with a very creative way to add what would appear to be a second story (interior balcony) which would lead to the rear and eventually to the Queens Chambers
or we could do something different
I am open for anything as long as its done with a Royal Flavor
Enjoy
Bob
- agram - 06-02-2007
I will take a look in the CS, i have an idea. Could you create a int cell, copy/paste the palace to that cell, and send me the interior cell. I want to see how high this is.
Thanks.
We have work to do Bob, let us breathe some new life to this forum.
- bob196045 - 06-02-2007
Taking a deep breath
heres the palace
- agram - 06-02-2007
Had a quick look at this, how about this:
for the entry we use something like velothi temple with doors on the sides, and in the back.
The side doors will go to the wings, and the back door will have corridors going up to the in_v_roomhol_01/queens master chambers, and down to the basement.The in_v_roomhol_01/queens master chambers will be above the entry. We could split the palace into two cells: upper and entry/basement.
I will make something, and show you how i see it.
- bob196045 - 06-03-2007
sounds good lets have a look
- agram - 06-03-2007
This is how i see it. The throne room (or whatever you want to call it) is the one with the platform. Behind is the door leading up to the bedroom. On the throne room sides are doors leading down. You will se that i placed several endcaps. One is behind the trone, and two are in the hallway going to the bedroom. This could be used as guard posts, or for decoration. Also i added one level under the palace, and left stairs that can be used if you want to add more levels. The int is little bigger then the ext, but i think it doesent matter. Feedback would be welcome.
NOTE: The cell is named palace. It has ext palace, int palace and some rooms i left if you want to add another level. It is all in one int cell so you can compare the int with ext.
- bob196045 - 06-03-2007
I looked it over and I like it
for some reason I would like to try a few other things
I messed around a bit and I think as far as the main center section goes I would like to try this
Double the scale of the in_v_roomhol_01 and then take the ex_vivec_hf_03 scale it to 1.5 turn it upside down and lower it into the center of the roomhol from the top, it now gives the appearance that we have a duel point interior as the exterior looks
from the top surface of the roomhol go down about 512 should do nicely
what ya think?
Bob