need a model for TES 3
|
08-31-2006, 10:57 PM,
|
|||
|
|||
I did revamp that model to be a little more centered, but when I played with it and a couple of the lbridge pieces, I couldn't get the lbridge pieces to line up with each other with a snap-to-grid setting of 32. Does anyone know what S2G setting will make those bridge pieces themselves line up?
Thanks, Steve |
|||
09-04-2006, 02:56 AM,
|
|||
|
|||
Hey Steve did anyone ever answer you on this in another forum?
ot have you figured it out allready Bob I could use another piece, this time to go with the imperial wall pieces an end cap , I dont understand why something like that wouldn't have been made ?
I am a free single guy again, but I am still addicted to Elder Scrolls
http://z10.invisionfree.com/Island_of_Ra...hp?act=idx Enjoy the Great taste of Diet Bob, with Zero Calories |
|||
09-04-2006, 08:39 AM,
|
|||
|
|||
If you look at those pieces where they are used in game, you see why, they were designed to run from one building to another, the end piece would usually be a tower or a keep.
MSN: ancientdwarvenchaosknight@hotmail.com
|
|||
09-04-2006, 02:04 PM,
|
|||
|
|||
Yes they are
in this case I'd like to use them as a type of railing, not a wall but a ledge around a base looky hopefully you can see these clearly enough to see what Im looking to do
I am a free single guy again, but I am still addicted to Elder Scrolls
http://z10.invisionfree.com/Island_of_Ra...hp?act=idx Enjoy the Great taste of Diet Bob, with Zero Calories |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)